Table of Contents
Advertisement
DOOR PANELS
Perlick column refrigeration comes ready to accept a customer
supplied overlay door panel and customer supplied handle.
Stainless steel door panels and Perlick handles are also
available, and are sold separately of the unit itself. Stainless
steel panels and handles can be purchased through an
authorized Perlick dealer.
STAINLESS STEEL DOOR PANELS
Stainless steel door panels for solid and glass door models
are available through an authorized Perlick dealer. Panels are
constructed of 304 stainless steel (front) and 403 (back plate)
and have a thickness of 3/4" (19). Always allow for panel
thickness when planning the finished opening depth.
Stainless steel panels come pre-drilled for a Perlick handle.
Please note that the Perlick Pro Handle is included with the
purchase of a stainless steel panel.
CUSTOM OVERLAY DOOR PANEL
Perlick columns come ready to accept customer-supplied door
panel and handle hardware. The thickness of the custom panel
can vary. A minimum 5/8" (16) thick panel is required, but
the thickness can be increased provided it does not exceed
the maximum panel weight is 65 lbs (29). Please note that
the combined door and overlay weight cannot exceed 242 lbs
(110). The depth of each model is 24" (610) without a finished
overlay. Allow for panel thickness when planning the finished
opening depth. Templates for 4" and 6" solid and glass door
models can be found on pages 11-14.
Reveals between panels can vary – 1/8" (3) is the minimum.
CAUTION
When installing a panel thicker than 3/4"
(19), the 90° stop may be required to prevent damage to the
unit and adjacent cabinetry.
CAUTION
As reveals between cabinetry and the unit
decrease, severe finger pinching can occur while the door is
closing.
10 | perlick.com/residential
PERLICK RESIDENTIAL COLUMN REFRIGERATION INSTALLATION INSTRUCTIONS
DOOR / SIDE PANEL INFORMATION
Finish sides of surrounding cabinetry — they will be visible
when the door is open. The height of the custom door panel
can extend beyond the typical panel height provided the door
and overlay combined do not exceed 242 lbs (110) .
See page 15 for screw zone for overlay panels. Hatch areas
should provide enough thickness for wood screw and overlay
attachment brackets.
SIDE PANELS
Units that are freestanding or partially built-in need to be
finished with custom panels. Custom panels can be built to
customer specifications to match surrounding cabinetry.
Advertisement
Table of Contents
