Table of Contents
Advertisement
Terminals
6
1. HDMI 1 IN Terminal (Type A)
(→ page 142, 143, 145)
2. HDMI 2 IN Terminal (Type A)
(→ page 142, 143, 145)
3. DisplayPort IN Terminal
(→ page 142)
4. COMPUTER IN/ Component Input Terminal (Mini
D-Sub 15 Pin)
(→ page 141, 144)
5. COMPUTER AUDIO IN Mini Jack (Stereo Mini)
(→ page 141, 143)
6. HDBaseT IN/Ethernet Port (RJ-45)
(→ page 146, 147)
7. HDBaseT OUT/Ethernet Port (RJ-45)
(→ page 61, 147)
8. AUDIO OUT Mini Jack (Stereo Mini)
(→ page 141, 143, 145)
9. USB-A Port (Type A)
(→ page 38)
10. LAN Port (RJ-45)
(→ page 150)
11. 3D SYNC Terminal (Mini DIN 3 Pin)
(→ page 44)
12. PC CONTROL Port (D-Sub 9 Pin)
(→ page 163)
Use this port to connect a PC or control system.
This enables you to control the projector using serial
communication protocol. If you are writing your own
program, typical PC control codes are on page 173.
3
1
2
7
4
12
11
13. REMOTE Terminal (Stereo Mini)
Use this terminal for wired remote control of the pro-
jector using the NEC remote control, RD-465E.
Connect the projector and our remote control, RD-
465E, using a commercially available wired remote
control cable.
NOTE:
• When a remote control cable is connected to the REMOTE
terminal, infrared remote control operations cannot be per-
formed.
• When [HDBaseT] is selected in the [REMOTE SENSOR]
and the projector is connected to a commercially-available
transmission device that supports HDBaseT, remote control
operations in infra-red cannot be carried out if transmission
of remote control signals has been set up in the transmission
device. However, remote control using infrared rays can be
carried out when the power supply of the transmission device
is switched off.
9
1. Introduction
5
9
8
13 10
Advertisement
Table of Contents
Troubleshooting
