The Gefen CAT5•1000 The CAT5-1000 requires just one CAT5 cable to transmit video, audio and control signals to the remote workstation. It essentially bundles the signals together before, during and after transmission so that cabling is reduced while reliable signal transmission is achieved.
READ THESE NOTES BEFORE INSTALLING OR • The CAT5•1000 will extend analog VGA video, analog 2 channel stereo audio, and USB up to 330 feet. • Supports resolutions up to 1920 x 1200. • USB 1.1 compliant. • Audio extension is designed for line-out audio sources only. Amplifi ed audio is not supported and may damage the CAT5•1000.
Features • Extends any VGA display up to 330 feet (100 meters) • Maintains 1920 x 1200 resolution video • Extends USB 1.1 compliant devices up to 330 feet • Audio is extended for multimedia applications • Uses one CAT-5e cable •...
SENDER PANEL DESCRIPTIONS Power LED This LED will become active once the included 5V DC power adapter is properly connected. 5V DC Power Connector Connect the included 5V DC power adapter to this connection port. Local Monitor Output Port Use this port to connect an local VGA monitor for monitoring purposes. This is useful if both local and extended locations need to view the VGA source.
RECEIVER PANEL DESCRIPTIONS Brightness Adjustment The Trim Pot is used for adjusting the brightness of the output video. If the image is too bright or too dark, adjust this setting until the desired brightness is reached. Power LED This LED will become active once the included 5V DC power adapter is properly connected.
CONNECTING AND OPERATING THE CAT5•1000 Connect the VGA source to the CAT5•1000 Sending unit using the supplied VGA cable. Optionally connect a local monitor to the local monitor output on the CAT5•1000 Sending unit. Connect the computer’s USB to the CAT5•1000 Sending unit using the supplied USB A to B cable.
CONFIGURING THE CAT5•1000 Jumper settings are used to set the focus of the picture and characters to the best possible sharpness. The jump ers in the CAT5•1000 Receiving unit are set at the factory as shown in the diagram below. The fi rst step to adjusting the video is to have the CAT5•1000 Sending unit and CAT5•1000 Receiving unit con nect ed to- gether with the CAT-5 cable that is going to be used in the in stal la tion.
Gefen has specifi cally engineered their products to work with the TIA/EIA-568-B specifi cation. Please adhere to the table below when fi eld terminating cable for use with Gefen products. Failure to do so may produce unexpected results and reduced performance.
SPECIFICATIONS Video Amplifi er Bandwidth ... 350 MHz Actual Bandwidth ... 120 MHz Input Video Signal ... 1.2 Volts p-p Input Sync Signal ... 5 Volts p-p (TTL) Horizontal Frequency Range ... 15-70 KHz Vertical Frequency Range ... 30 - 170 Hz Video In...
Need help?
Do you have a question about the CAT5-1000 and is the answer not in the manual?
Questions and answers