Dhcp Client Setting; Tcp/Ip Setting; Returning To Default Settings (Network); Restart Network Function - Sharp PG-LW3000 Operation Manual

2 DHCP Client Setting

Connect the LAN cable before turning the
projector on. If not, the DHCP Client function
does not work.
Selectable items
On Obtains configuration
parameters for TCP/IP network
automatically.
Off Sets the TCP/IP manually.
Select "On" for "DHCP Client". "Obtaining IP
Address..." appears, then the menu screen
appears. Confirm the parameters of IP
Address, Subnet Mask and Gateway on the
TCP/IP screen.
If the DHCP server is not available, "Could not
obtain IP Address." appears.
In this case, set the TCP/IP manually. (See the
item 3.)

3 TCP/IP Setting

Set the TCP/IP manually.
1
Select "Off" for "DHCP Client",
then press ENTER.
2
Select "TCP/IP", then press
ENTER.
3
Enter "IP Address" using P, R, Q
and O, then press ENTER.
Setting the TCP/IP
1
IP Address
2
Subnet Mask
0 0 0 .
Gateway
4
Enter "Subnet Mask" using P, R,
Q and O, then press ENTER.
5
Enter "Gateway" using P, R, Q
and O, then press ENTER.
Description
Network
9 2 . 1 6 8 . 1 5 0 . 0 0 2
5 5 . 2 5 5 . 2 5 5 . 0 0 0
0 0 0 . 0 0 0 . 0 0 0
Menu operation n Page
Selectable items
IP Address Factory default setting:
192.168.150.002
Enter an IP address
appropriate for the network.
Subnet Mask Factory default setting:
255.255.255.000
Set the subnet mask to the
same as that of the computer
and equipment on the
network.
Gateway Factory default setting:
000. 000. 000. 000
* When not in use, set to "000.
000. 000. 000".
Note
• Confirm the existing network's segment (IP
address group) to avoid setting an IP address
that duplicates the IP addresses of other
network equipment or computers. If
"192.168.150.002" is not used in a network
with an IP address of "192.168.150.XXX", you
don't have to change the projector IP address.
• For details about each setting, consult your
network administrator.
4 Returning to Default
Settings (Network)
This function allows you to initialize the
Network settings you have made in the
projector.
Note
• If the values for IP Address, Subnet Mask or
Gateway of the projector have been returned
to the default settings, the computer cannot
be connected to the projector depending on
the computer's network settings.

5 Restart Network Function

Restarts the network function.
Perform this function when the projector
cannot be controlled via the network.
40
Description
55