Powering on/off
Connecting the power cord
Make sure that the supplied power cord is securely fixed to the projector body to prevent it from being removed easily.
For details of power cord handling, refer to "Read this first!" (x page 2).
Attaching
1)
Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the plug completely in the correct direction.
Removing
1)
Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2)
Remove the power cord connector from the <AC IN> terminal.
Power indicator
The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Confirm the status of the power indicator
<ON(G)/STANDBY(R)> before operating the projector.
Power indicator <ON(G)/STANDBY(R)>
Indicator status
No illumination
Lighting
Red
Blinking
Lighting
Green
Blinking
Lighting
Orange
Blinking
Chapter 3 Basic Operations - Powering on/off
The projector is turned off. (The power cord is unplugged.)
The power cord is plugged.
The projector is in standby mode, after the cooling is completed.
The projector is in warming up after turning on the power.
The projector is in projected state after a while.
The projector is cooling down.
The power is switched off after a while. (Changes to the standby mode.)
Projecting.
The projector is in ready mode with Power management function.
The abnormal inside is detected. (Warning)
The temperature inside the projector is abnormally high. (Warning)
x
Status
ENGLISH - 33