Connecting To Composite Video Source Devices - ViewSonic PA502S User Manual

Connecting to composite video source devices

Examine your Video source device to determine if an unused composite output jack is
available:
• If so, you can continue with this procedure.
• If not, you will need to reassess which method to use to connect to the device.
1. Take a Video cable and connect one end to the composite Video output socket of the
Video source device.
2. Connect the other end of the video cable to the VIDEO socket on the projector.
If the selected video image is not displayed after the projector is turned on and the correct
video source has been selected, check that the Video source device is turned on and operating
correctly. You must also check that the signal cables have been connected correctly.
When the component video is not available, use the composite video connection method to
connect to this device. See "Connecting to Video source devices"
18
for details.