Table of Contents
Advertisement
Switching input signal
The projector can be connected to multiple devices
at the same time. However, it can only display one
full screen at a time.
If you want the projector to automatically search for
various signals, please confirm that the Quick Auto
Search function in the SYSTEM menu is switched
ON.
You may also press the source selection button
on the remote control or search for available input
signals to manually select the desired signals.
1.
Press [Source] to display the source selection
column.
2.
Keep pressing the / until you arrive at the
desired signal, then press [Enter].
Once detected, the selected source information will display on the screen for
seconds. If there are multiple devices connected to the projector, repeat steps 1 to 2
to search for another signal.
For display resolutions of this projector, please refer to
To achieve the best image display effects, you should select and use an input signal that
outputs at this resolution. Any other resolutions will be scaled by the projector depending upon
the aspect ratio setting, which may cause some image distortion or loss of picture clarity. See
"Selecting the aspect ratio"
for details.
23
"Projector
specifications".
Advertisement
Table of Contents
