Register Map - JAI RM/TM-1327GE Series User Manual

ii Set PLC_Q4_Variable0 to PLC_I0 (Trigger Line)
iii Set PLC_Q5_Variable0 to One. (Integration signal always on.)
Example 2: Setting the camera to accept internal trigger signal generated via Timer 1:
Set ExposureMode to one of Asynchronous modes.
Setup the Timer (Pulse Generator)
a. Set TimerSelector to Timer1.
b. Set TimerTriggerSource to Continuous.
c. Set TimerDurationRaw, TimerDelayRaw, TimerGranularityFactor according to values
below.
i These are example values only; other combinations can also be used.
ii TimerFrequency tells you the rate of the trigger, hence frame rate.
TimerDurationRaw
TimerDelayRaw
TimerGranularityFactor
Setup SignalRoutingBlock
a. Goto IPEngine > ProgrammableLogicController > SignalRoutingBlock
b. Set PLC_I4 to "Internal CAM_STROBE_Out".
c. Set PLC_I7 to Timer1Out.
Setup the ProgrammableLogicController (PLC) to route the Timer1 output to the camera's trigger line.
a. Goto IPEngine > ProgrammableLogicController > LookupTable
i Set Q4 > PLC_Q4_Variable0 to PLC_I7 (Trigger Line)
ii Set Q0 > PLC_Q0_Variable0 to PLC_I4 (Strobe output)
iii Set Q5 > PLC_Q5_Variable0 to One. (Integration signal always on.)
Example 3: Setting up Integration Signal routing from external source:
Goto IPEngine > ProgrammableLogicController > SignalRoutingBlock
Set PLC_I3 to External_INT_In
Goto IPEngine > ProgrammableLogicController > LookupTable
Set Q5 > PLC_Q5_Variable0 to PLC_I3. (Integration signal always on.)
5.9

Register Map

Category / Feature
AcquisitionAndTriggerControls
AcquisitionMode
AcquisitionFrameCount
AcquisitionStart
AcquisitionStop
50
RM/TM-1327GE Series
<0.5 fps
200
10000
7000
Read/
Value Range
Write
RW Continuous
SingleFrame
MultiFrame
ContinuousRecording
ContinuousReadout
SingleFrameRecording
SingleFrameReadout
RW 1-255
RO Execute Command
RO Execute Command
Configuring the Camera
1 fps 5 fps
200 200
4550 750
7000 7000
Default Value
Continuous
1
Visibility
Level
Beginner
Beginner
Beginner
Beginner