Gateway S-7310M Replacement Instructions Manual page 8

9 If you are removing a memory module, gently press
outward on the clip at each end of the module until
the module tilts upward.
10 Pull the memory module out of the slot.
Technical Support
See the label on the bottom of the notebook for Customer
Care Information. See your hardware guide for important
safety, regulatory, and legal information.
2
11 Hold the new or replacement module at a 30-degree
angle and slide it into the empty memory slot. This
module is keyed so it can only be inserted in one
direction. If the module does not fit, make sure that
the notch in the module lines up with the tab in the
memory bay.
Important
12 Gently push the module down until it clicks in
place.
13 Replace the memory bay cover, then tighten the
cover screws.
14 Replace the keyboard screw.
15 Insert the batteries, then turn your notebook over.
16 Reconnect the optional port replicator.
-OR-
Connect the power adapter, the modem cable, and
the network cable.
17 Turn on your notebook.
© 2006 Gateway, Inc. All rights reserved. Gateway and
eMachines are trademarks or registered trademarks of
Gateway, Inc. in the United States and other countries.
All other brands and product names are trademarks or
registered trademarks of their respective companies.
www.gateway.com
Replacing the Memory Module
Use only memory modules designed for your
Gateway notebook.