Terminals - Dukane 6780WU User Manual

Terminals

6
1. HDMI 1 IN Terminal (Type A)
(→ page 144, 145, 147)
2. HDMI 2 IN Terminal (Type A)
(→ page 144, 145, 147)
3. DisplayPort IN Terminal
(→ page 144)
4. COMPUTER IN/ Component Input Terminal (Mini
D-Sub 15 Pin)
(→ page 143, 146)
5. COMPUTER AUDIO IN Mini Jack (Stereo Mini)
(→ page 143, 145)
6. HDBase T IN/Ethernet Port (RJ-45)
(→ page 148, 149)
7. HDBaseT OUT/Ethernet Port (RJ-45)
(→ page 63, 149)
8. AUDIO OUT Mini Jack (Stereo Mini)
(→ page 143, 145, 147)
9. USB-A Port (Type A)
(→ page 122)
10. LAN Port (RJ-45)
(→ page 152)
11. 3D SYNC Terminal (Mini DIN 3 Pin)
(→ page 46)
12. PC CONTROL Port (D-Sub 9 Pin)
(→ page 178)
Use this port to connect a PC or control system.
This enables you to control the projector using serial
communication protocol. If you are writing your own
program, typical PC control codes are on page 188.
3 1 2
4
7
12 11
13. REMOTE Terminal (Stereo Mini)
Use this terminal
projector using the remote control for PX750U/
PH1000U/PH1400U series.
Connect the projector and
465E, using a commercially available wired remote
control cable.
NOTE:
• When a remote control cable is connected to the REMOTE
terminal, infrared remote control operations cannot be per-
formed.
• When [HDBaseT] is selected in the [REMOTE SENSOR]
and the projector is connected to a commercially-available
transmission device that supports HDBaseT, remote control
operations in infra-red cannot be carried out if transmission
of remote control signals has been set up in the transmission
device. However, remote control using infrared rays can be
carried out when the power supply of the transmission device
is switched off.
10
1. Introduction
5
9
8 13 10
for wired remote control of the
our remote control, RD-