[Geometric Correction] - Dukane 6780WU User Manual

[GEOMETRIC CORRECTION]

MODE
Set pattern for correcting distortion. If [OFF] is selected, the [GEOMETRIC CORRECTION] becomes ineffective.
If you need to change either the [MENU ANGLE] or [MENU POSITION], make sure to change these before performing
the [GEOMETRIC CORRECTION]. If either of them is changed after performing the [GEOMETRIC CORRECTION],
corrected values will be reset to the default values.
KEYSTONE
Correct distortion in horizontal and vertical directions.
HORIZONTAL ��������� Adjustments when projecting from a diagonal direction to the
screen�
VERTICAL �������������� Adjustments when projecting from the top or bottom direction to
the screen�
TILT ����������������������� Adjusts the distortion when performing trapezoidal correction with the screen moved in the vertical direction
using the lens shift�
THROW RATIO ������� Adjusts according to the projection ratio of the optional lens used�
* The values for NP40ZL and NP42ZL are tentative�
NOTE:
• When power is supplied to the device, the adjustment value of the [KEYSTONE] used previously is retained even if the gradient
of the device is changed.
• As electrical correction is carried out by [KEYSTONE], the brightness may be reduced or the screen quality may deteriorate
sometimes.
Model name of lens Adjustment range
unit
NP11FL
NP30ZL
NP12ZL
NP13ZL
NP14ZL
NP40ZL
NP41ZL
NP42ZL
8
8–10
12–15
15–30
29–47
8-11
13-30
30-60
103
5. Using On-Screen Menu