Advertisement
1
Before you begin installing the fan, Switch power off
at Service panel and lock service disconnecting means
to prevent power from being switched on accidentally.
When the service disconnecting means cannot be
locked, securely fasten a prominent w arning device,
such as a tag, to the service panel.
4
Remove keeper from pin. Pull pin out and
replace keeper, save for later.
7
Insert downrod into yoke on top of
fan body. Align the hole in the down -
rod with hole in the y oke. Insert pin
through the yoke and downrod until
the point appears on the other side.
Install the keeper.
© 2011 Monte Carlo Fan Company
2
Before installing this fan mak e sure the outlet
box is properly installed to the house structure.
To reduce the risk of fire, electric shock, or per -
sonal injury, mount to outlet bo x or supporting
system acceptable for fan support.
(Mounting must support at least 35 lbs.)
5
Loosen the 2 set screws and nuts till y ou can
not feel them on inside of y oke.
8
Tighen set screws and nuts to secure
downrod in yoke.
3
3
Use metal outlet box suitable for fan support
(must support 35 lbs). Before attaching fan to
outlet box, ensure the outlet bo x is securely
fastened by at least two points to a structur al
ceiling member ( a loose bo x will cause the fan
to wobble). Use only the screws provided
with the outlet box.
6
Place canopy and then yoke cover over downrod
as shown. Then thread the lead wires and safe -
ty cable from fan through the downrod as
shown.
9
Check the fan motor for shipping sta -
bilizer and remove if present.
6/1/2012
Advertisement
