Table of Contents
Advertisement
MS-250 Mixed Signal Oscilloscope Option
INTRODUCTION
Overview
The MS-250 Oscilloscope Mixed Signal Option is a powerful solution for the challenge of
measuring multiple, mixed signals in a single oscilloscope. An enhancement tool to the LeCroy
WaveRunner Xi Series and WaveSurfer Xs Series oscilloscopes, the MS-250 extends their
testing range by adding 18 digital channels for display or triggering.
The MS-250 is ideally suited for embedded controller testing where there is a proliferation of
analog signals (comparators, voltage sources, sensor/actuator signals, etc.) coincident with digital
signals (address or data lines, control signals, or peripheral serial data signals). Users can easily
debug signals using standard oscilloscope tools such as cursors, measurement parameters, and
zooming.
Both oscilloscopes usable with the MS-250 feature large, bright color displays to facilitate signal
viewing, plus all the connectivity and documentation capabilities needed to quickly record and
distribute information.
This MS-250 manual assumes that you have a basic understanding of discrete electronics, logic
analyzers, and LeCroy oscilloscopes, specifically the LeCroy oscilloscope that the MS-250
system will be used with. When practical or necessary there are details on specific oscilloscope
features included in this manual.
Warranty
The MS-250 is warranted for normal use and operation, within specifications, for a period of one
year from shipment. LeCroy will either repair or, at our option, replace any product returned to
one of our authorized service centers within this period. However, in order to do this we must first
examine the product and find that the defect is due to workmanship or materials and not due to
misuse, neglect, accident, or abnormal conditions or operation.
LeCroy shall not be responsible for any defect, damage, or failure caused by any of the following:
a) attempted repairs or installations by personnel other than LeCroy representatives, or b)
improper connection to incompatible equipment, or c) for any damage or malfunction caused by
the use of non-LeCroy supplies.
Spare and replacement parts, and repairs, all have a 90-day warranty.
The oscilloscope's firmware has been thoroughly tested and is presumed to be functional. This
includes MS-250 specific firmware. Nevertheless, it is supplied without warranty of any kind
covering detailed performance. Products not made by LeCroy are covered solely by the warranty
of the original equipment manufacturer.
Returning a Product for Service or Repair
If you suspect that you have a problem with the MS-250, you should first contact your local
LeCroy service center so that they can ascertain whether this component is defective.
6
ISSUED: June, 2009
MS-250-OM-E Rev C
Advertisement
Table of Contents
