Table of Contents
Advertisement
Int. Mic Wind Cut
For selecting whether to cut the low frequencies of
the audio input signals (low-cut) from the built-in
microphone. Set this item to "On" to reduce wind
noise from the microphone.
[Setting Values: On
Memo :
This item is enabled in the following cases.
0
When the [CH-1] or [CH-2] selection switch is
0
set to "INT". O
[CH1 INT] is set to "Int. Mic L" or [CH2 INT] is
0
set to "Int. Mic R".
(A P110 [ CH1 INT ] )
(A P110 [ CH2 INT ] )
Int. Mic Stereo Enhancer
For setting the enhancement level of the stereo
effect of the built-in microphone.
0
On
:
Enhances the stereo effect.
Off:
0
Does not enhance the stereo effect.
[Setting Values: ROn
Memo :
This item is enabled in the following cases.
0
Both [CH-1] and [CH-2] selection switches
0
are set to "INT". O
[CH1 INT] is set to "Int. Mic L" and [CH2
0
INT] is set to "Int. Mic R".
(A P110 [ CH1 INT ] )
(A P110 [ CH2 INT ] )
Monitor
For setting the audio output from the [x] jack or the
speaker.
Stereo:
0
Outputs audio from [CH1] to L and audio from
[CH2] to R.
Mix:
0
Generates a mixed audio output from [CH1] and
[CH2].
CH1:
0
Outputs only the audio input from [CH1].
CH2:
0
Outputs only the audio input from [CH2].
[Setting Values: RStereo, Mix, CH1, CH2]
112
A/V Set Menu
, ROff]
, Off]
Memo :
If both [CH1] and [CH2] are input signals of the
0
built-in microphone, "Mix" cannot be selected for
the output from the [x] jack.
"Stereo" cannot be selected for speaker output
0
in the Media mode.
Alarm Level
For selecting whether to turn on the warning tone
as well as setting the volume.
The warning tone is output from the monitor
speaker or [x] terminal.
[Setting Values: High, Low, ROff]
Test Tone
For specifying whether to output the audio test
signals (1 kHz) during color bar output.
[Setting Values: On, ROff]
Audio On FULL AUTO
For setting whether to enable Auto for audio when
Full Auto is enabled using the [FULL AUTO] button.
SW Set:
0
The audio recording mode follows the settings
below.
When the handle unit is connected: Follows
0
the [AUDIO SELECT CH-1 AUTO/MANU] or
[AUDIO SELECT CH-2 AUTO/MANU] switch
setting.
When the handle unit is not connected:
0
Follows the MENU setting (AUTO/MANUAL
in the audio level setting).
Auto:
0
Sets audio recording mode to the forced auto
mode.
[Setting Values: SW Set, RAuto]
Advertisement
Table of Contents
