Installing The Battery; Keyboard-Controller Board; Removing The Keyboard-Controller Board - Dell Alienware m17 R2 Service Manual

Steps
1. Ensure that the battery cable has been disconnected from the system board.
2. Remove the eight screws (M2x4.5) that secure the battery to the palm-rest assembly.
3. Remove the battery from the palm-rest assembly.

Installing the battery

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Place the battery on the palm-rest assembly.
2. Replace the eight screws (M2x4.5) that secure the battery to the palm-rest assembly.
Next steps
1. Install the 2230 solid-state
2. Install the 2280 solid-state
3. Install the battery.
4. Follow the procedure in

Keyboard-controller board

Removing the keyboard-controller board

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
drive. (if applicable)
drive. (if applicable)
After working inside your
Before working inside your
computer.
computer.
31