Amcrest IP2M-848EW/ User Manual page 105

•
Record Type: These columns designate which recording type should be recorded to which event type. Check the box
at the intersection of the record type and event type to designate where that recording should be sent to.
To reset to default settings, click the Reset Defaults button. To refresh the page, click the Refresh button. To save the
settings, click the Save button.
5.9.2.2. SD Card
This tab is where the user can change SD card settings. Below is a screenshot of the SD Card tab:
Below is an explanation of the fields on the SD Card settings tab:
•
Device Name: This column designates the name of the SD card that is currently in the camera.
•
Status: This column designates the status of the SD card.
•
Attribute: This column designates the read/write attributes for the SD card. By default, this is Read &
Write.
•
Used Capacity/Total Capacity: This column shows the available memory on the SC card.
Read Only: This button allows the user to designate an SD card as read only.
•
Hot Swap: This button allows the user to physically remove the SD card and replace it with another safely.
•
Refresh: This button refreshes the SD card table.
•
Format: This button formats the SD card.
5.9.2.3 FTP
This tab is where the user can change FTP settings. Below is a screenshot of the FTP tab:
Below is an explanation of the fields on the FTP settings tab:
•
Enable: This checkbox allows the user to enable FTP uploading for the camera's recorded media.
•
Server Address: This field allows the user to designate a DDNS address for the FTP server.
105