Table of Contents
Advertisement
LEARNING/ REMOVING A REMOTE TEMPERATURE/HUMIDITY SENSOR (CHANNEL)
After replacement of batteries of a particular remote temperature/humidity sensor, it is necessary to learn the remote
temperature/humidity sensor again in the learning mode. On the other hand, when a user wants to decrease the number
of remote temperature/humidity sensors to be applied, they may remove the remote temperature/humidity sensors so that
the data from this channel will not be displayed in the indoor weather station. The below procedures describe how to "re-
learn" or "remove" a channel:
1.
Press and hold the SET key until the digits "Lcd" starts flashing.
2.
Press shortly the SET key eleven times to enter Learn/ Remove setting of channels. The digits "Lrn", "CH" and the
channel icons will be flashing.
Flashing
3.
Press Plus to select Channel 1. The digit "1" will be flashing.
4.
Press Plus to set Channel 1 to "Re-learn" state (The channel icon will be flashing), or press Minus to remove
Channel 1 (The channel icon will disappear).
5.
Press SET key to select Channel 2. The digit "2" will be flashing.
6.
Repeat the above steps to Channel 2 to 3, setting them either in "re-learnt" or "removed" state.
Note: Once a channel is removed, the indoor weather station will be "disconnected" from the channel and the data
transmitted by this channel cannot be viewed at the indoor weather station.
THE NUMBER OF REMOTE TEMPERATURE/HUMIDITY SENSOR TO BE SAVED INTO THE SYSTEM MEMORY
Up to 3 remote temperature/humidity sensors can be received by the indoor weather station. The user may decide the
number of remote temperature/humidity sensor data to be saved to the permanent memory of the indoor weather station.
For instant, user may apply 3 remote temperature/humidity sensors but set to save the data only from 2 particular remote
temperature/humidity sensors. To set the number of remote temperature/humidity sensor s whose data are to be saved in
the system memory:
1.
Press and hold the SET key until the digits "Lcd" starts flashing.
2.
Press and release the SET key twelve times to enter remote temperature/humidity sensor number setting. The digit
"Enr" will be flashing.
3.
Use the Plus and Minus key to select the number of remote temperature/humidity sensor to be used with the
weather station (up to 3 transmitters)
4.
Press the SET key one more time to confirm and go back to the normal display mode.
Digits flashing
10
Digit flashing
Advertisement
Table of Contents
