Table of Contents
Advertisement
Quick Links
Solar Powered Wireless Temperature Station
LCD display
Model TX62U-IT/Solar-powered Transmitter (Sensor):
Solar panel
Model WS-8120U-IT
INSTRUCTION MANUAL
Solar panels
Function
keys
%
Stands
LCD shows temperature readings
Transmits outdoor temperature to indoor receiver using 915 MHz
signals
200 FT. wireless transmission range (open air)
Built-in rechargeable alkaline power cells store solar power for
continuous operation
No batteries necessary (internal power cells cannot be replaced;
contact customer service for a replacement sensor)
Able to charge in low light environments.
1
Wall mount
Battery cover
Advertisement
Table of Contents
Related Manuals for La Crosse Technology WS-8120U-IT
Summary of Contents for La Crosse Technology WS-8120U-IT
- Page 1 Model WS-8120U-IT Solar Powered Wireless Temperature Station INSTRUCTION MANUAL LCD display Solar panels Wall mount Function keys Battery cover Stands Model TX62U-IT/Solar-powered Transmitter (Sensor): LCD shows temperature readings Transmits outdoor temperature to indoor receiver using 915 MHz signals ...
-
Page 2: Battery Compartment
INITIAL SETUP (USING INCLUDED SOLAR RECHARGEABLE BATTERIES FROM THE FACTORY) 1. Open battery compartment on the back of the Weather Station and make sure that the battery switch under the battery compartment is to the left. If it is not, please slide the switch to the left before proceeding. -
Page 3: Idle Mode
SOLAR-POWERED TRANSMITTER OPERATION MODES (1) NORMAL MODE: NORMAL MODE occurs when the battery voltage is 2.5V or greater. It measures and transmits temperature data to the indoor receiver every 8 seconds. It checks the brightness level of the surrounding environment every 5 seconds. ... -
Page 4: Program Menu
SET button Solar panels PLUS button LCD display PROGRAM MENU: SET THE TIME: Press and hold the SET button for 3 seconds to enter the time setting mode. HOUR: The Hour digits will flash. Press and release the PLUS button to set the Hour. Press and release the SET button once. -
Page 5: Display Modes
DISPLAY MODES: Press and release the SET button to view different display modes: Outdoor temperature in the first line on the left side and outdoor minimum in the second line on the left side Shows indoor temperature in the first line on the right side and indoor humidity in the second line on the right ... - Page 6 WALL MOUNTING 1. Install a mounting screw (not included) into a wall—leaving approximately 3/16 of an inch (5mm) extended from the wall. 2. Place the Weather Station onto the screw, using the hanging hole on the backside. Gently pull the Weather Station down to lock the screw into place. NOTE: Always ensure that the Weather Station locks onto the screw before releasing.
- Page 7 Note: For best performance, standard alkaline batteries should be replaced at least once every 2 years to maintain the best running accuracy. Ensure that the batteries used are new and the correct size. Please help in the preservation of the environment and return used batteries to an authorized depot.
-
Page 8: Specifications
Ltd or La Crosse Technology, Ltd’s authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. - Page 9 Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: La Crosse Technology 2817 Losey Blvd. S. La Crosse, WI 54601 www.lacrossetechnology.com/support...