Advertisement
Soldering Net
Remotely manage and monitor as many stations as your Windows PC can handle.
1. Download the JBC Manager software and the user manual from www.jbctools.com/manager.html
2. Connect the stations via USB-B connector and the PC will automatically detect them.
3. The notification
will be displayed on the station.
Functions:
- Set all the station parameters
from your PC.
- Organize groups of stations and
set all their parameters at the
same time.
- Store specific configurations for
later uses.
- Analyze the soldering graphics
of the stations on your PC and
export them.
Update the station software
1. Download the JBC Update File from
www.jbctools.com/software.html and save
it on a USB flash drive. Preferably one with
no other files.
JBC
Update File
8
8
JBC
Manager
software
any JBC station
USB Hub
2. Insert the USB flash drive to the station.
The icon
is diplayed while updating.
Maintenance
Before carrying out maintenance or storage, always allow the equipment to cool.
- Clean the station screen with a glass cleaner
or a damp cloth.
- Use a damp cloth to clean the casing and
the tool. Alcohol can only be used to clean
the metal parts.
- Periodically check that the metal parts of
the tool and stand are clean so that the
station can detect the tool status.
- Maintain tip surface clean and tinned prior
to storage in order to avoid tip oxidation.
Rusty and dirty surfaces reduce heat
transfer to the solder joint.
- Periodically check all cables and tubes.
- Replace a blown fuse as follows:
Fuse holder
1. Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
w w w.jbctools.com
Clean periodically
Fuse
Fuse holder
2. Press the new fuse into the fuse holder
and replace it in the station.
9
9
Advertisement
