Viking VSOE130 Use & Care Manual page 14

Clocks and Timers
(Digital Display - Select / French Door Models)
2. Set the desired baking time:
Once the start time is set, the display will switch to :00 and
the words SET, COOK and TIME will appear on the right side of the display. You will now enter the desired baking time. Add 30
minutes to the desired bake time to allow for preheat.
Turn the "SET" knob until the desired baking time is displayed in hours and minutes. Once the desired bake time is set, the word SET
will disappear and the word DELAY will appear in the display indicating that the Bake Hours program has been set.
NOTE: For Double Ovens, the word DELAY will show with either UPPER OVEN or LOWER OVEN depending on which oven has been
selected.
3. Set the Oven Function selector to the desired function – BAKE, CONVECTION BAKE, OR TRUCONVEC™, etc.
4. Set the temperature control knob to the desired baking temperature.
5. The automatic time bake program is now set!
NOTE: The display will continue to show the amount of bake time that was programmed (this will remain until the programmed start
time is reached). You can return the display to clock mode by pressing the "CLOCK" button on the Select models or "PROBE" on the
French door models. Notice that a small clock will be displayed in the upper right corner to indicate that a program is in progress.
Switch back to the timer mode by pressing the "BAKE HOURS" button.
6. When the specified time is reached, the oven will automatically turn on. It will bake for the programmed amount of time at the
selected temperature.
NOTE: At one minute from the end of the specified bake program, the oven timer will beep once. At the end of the specified bake
program, the oven will automatically turn off and the timer will sound a series of three beeps. This will continue until the "START TIME"
button is pressed. The display will then return to displaying the time.
NOTE: Setting the remaining duration time to :00 will cancel the Automatic Bake program.
Sabbath Mode (Digital Display Select models only)
To set the Sabbath Mode
1. Press the "CLOCK" button until it beeps.
2. Turn SET knob until SAB appears in the display.
3. Press the "CLOCK" button to toggle between NO or ON. NO is the default setting.
4. After selecting ON, turn SET knob to done.
5. Press "CLOCK" button to clear display.
To remove Sabbath Mode
Follow the same steps above and select the NO setting.
Night Light
(French Door model only)
To activate the nightlight feature, press the "START TIME" and "PROBE" buttons and
hold for 3 seconds. To turn the nightlight feature off, press the same two buttons
and hold for 3 seconds
14
SET
CLOCK MIN/SEC BAKE START
SET
TIMER TIME TIME
Select Models
SET
NIGHT LIGHT
MIN/SEC BAKE START PROBE
SET
TIMER TIME TIME