Health O Meter Professional 2500KG User Instructions page 9

ASSEMBLY INSTRUCTIONS (CONT.)
Ramp Assembly Instructions
Follow these instructions for moving the ramp to the opposite side of the scale, or for adding
a second ramp to the scale (B2500RAMP option):
1. On the side of the platform opposite to
the ramp, remove the guardrail mounted
to the end of the platform by unscrewing
and then removing the four guardrail
assembly screws. If adding a second
ramp, skip to step 5.
2. Fold the ramp onto the platform surface.
Remove the screws attaching the two
rubber bumpers, located on the side of
the platform. Remove the bumpers, and
re-install them on the opposite side of the
platform using the appropriate mounting
holes.
3. Loosen the screws holding each ramp
holder to the platform. There are four
screws on each side of the ramp. To
obtain access to the screws on the
underside of the platform, remove the
two black feet. After removing the screws
and the ramp holder, replace the feet.
Completely hand tighten the feet, then
turn them back 1-1/2 full turns.
4. Remove the ramp holders by pulling
them out of the platform. Separate the
ramp from the ramp holders.
5. On the side of the platform without a
ramp, remove the two feet on the
underside of the platform. Insert the
ramp holders but do not insert the
screws at this point. Insert the ramp
between the ramp holders, then insert
and tighten the assembly screws.
Replace the feet by completely hand
tightening, then turn back 1-1/2 full turns.
If utilizing just one ramp, re-install the
guardrail on the side of the platform
where the ramp was located.
P/N UM2500KL_2500KG_E_REV20181128
Guardrail Assembly Screws
Ramp Holder
Ramp
Ramp Holder
9