Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS (CONT.)
5. Screw the four feet into the underside of
the platform. Completely hand tighten
the feet, then turn them back 1-½ full
turns. This allows for proper load cell
operation. Carefully tilt the scale back to
an upright position on the floor.
Warning: Do not drop scale, as this
can permanently damage the load
cells. Adjust the feet as needed to level
the scale. Ensure that the feet are not
completely tightened into the platform.
*** If you are assembling this scale to use with the optional seat attachment, stop here
and for the remaining instructions see the CHAIRACC manual included in the seat
assembly carton.
6. Obtain the display head and align the
four holes on the back of the display
head with the four mounting holes on the
silver display support. Using four of the
included M4 0.7 x 10mm screws (Part
B), fasten the display head onto the
display support using a Phillips head
screwdriver to tighten the screws.
7. Obtain the plastic bracket cover. Clip the
load cell cable into the divot in the middle
of the cover and align the cover over the
silver display support. Obtain the two
remaining M4 0.7 x 10mm screws (Part
B). Using a Phillips screwdriver, attach
the bracket cover over the silver display
bracket.
8. Plug the load cell cable into the load cell
port on the rear of the display head.
Note: Do not attach the AC adapter
power cord into the back of the display
assembly at this point.
9. Attach the two display support covers
(Part E) on the front and back of the
scale as shown. Scale assembly is
complete. See Powering the Scale on
page 10 for battery/AC adapter
instructions. If powering the scale via AC
adapter, see the next step for attaching
the adapter holder.
10. Optional Step – For powering the
scale via AC power adapter. Attach the
adapter holder to the handrail using the
two included sheet metal screws (Part
C). Use a Phillips head screwdriver to
tighten the screws.
P/N UM2500KL_2500KG_E_REV20181128
8
Ensure that the
spacer spring is on
the bolt of the foot
before inserting into
the platform.
Advertisement
Table of Contents
