Setup Settings - Sony LS42X Operating Instructions Manual

010COV.book Page 26 Monday, October 12, 2009 4:42 PM

Setup Settings

For how to select and change settings, see the section of "Overview of the Menus" (page 21).
Menu
Language
Timer Setting
Clock Set
Date Set
Time Set
Clock Display
On/Off Timer
ECO Mode
Off/Low/High
Status Display
Speaker Out
Advanced Setup
Control Setting
Index Number
Control Mode
Display+Remote
26
GB
Function and operation
Select from the language settings shown. Select "English", "Français", "Deutsch",
"Español", "Italiano" or " ".
You can adjust time, display the built-in clock, or set the timer to make the display
power on/off at a predetermined time.
Note
If the built-in clock tends to lose time, the internal battery may be exhausted. Please
contact your authorized Sony dealer to have the battery replaced.
Sets the day of the week and the hour of the day.
Sets the date (year, month, date). The day is automatically set.
Sets the time.
Select "On" or "Off". If you select "On", when the remote control's DISPLAY
button is pressed, it shows the current time which was set.
Sets the day of the week and the hour of the day.
Note
This cannot be used unless the "Timer Setting" has been set.
Changes the backlight brightness, reducing energy conservation. Higher settings
save less energy.
Select "On" or "Off". If you select "On", the input signal and "Aspect" information
show on the screen for about 5 seconds when the display is turned on. When you
switch the input signal, the input signal information shows for about 5 seconds.
Tip
You can display the input signal and "Aspect" information by using DISPLAY
button on the remote control.
Select "On" or "Off". If you select "On", sound is output from the speakers.
Enter more detailed settings.
This menu is used for settings of operation of the display and the remote control.
You can change the index number of the display if necessary. Select to set the index
number of the display with F/f buttons on the display, and press
confirm the setting.
Note
The "Index Number" cannot be set with the remote control.
Set to control the display from the remote control or from the display.
Note
When this item is operated, the available modes will differ depending on whether
you select by the remote control or the display. When setting this item with
button on the remote control, you can select only "Display+Remote" or "Remote
Only". When setting this item with
"Display+Remote" or "Display Only".
Enables operation of the display with the control buttons on the display and the
remote control.
button to
button on the display, you can select only
FWD-S42E1
4-160-338-01(1)