Sony LS42X Operating Instructions Manual page 75

010COV.book Page 33 Monday, October 12, 2009 4:42 PM
Problem
Remote control does not operate.
Cannot connect to the network.
Possible Remedies
• Check the polarity of the batteries or replace the batteries.
• Point the remote control at the remote control sensor of the display.
• Keep the remote control sensor area clear from obstacles.
• Check "Control Setting" (page 26).
• Check whether a cable is connected to the CONTROL S IN jack
(BKM-FW21 not supplied). The remote control cannot be used while
the display is controlled via a CONTROL S connection.
• Fluorescent lamps can interfere with remote control operation; try
turning off the fluorescent lamps.
• Plug the cable firmly into the network terminal of the optional
adaptor (BKM-FW32/FW50/FW55, not supplied).
• Check the network settings of the PC.
• Reset to the default settings by assigning the "All Reset" setting on
the "Setup" setting menu, and then assign the appropriate settings of
the network again.
GB
33
GB
FWD-S42E1
4-160-338-01(1)