Setup Settings - Sony KLH-W26 Operating Instructions Manual

Setup Settings

: :
Language
Timer Setting
ECO Mode
Auto Shut Off
Advanced Setup
24
GB
: :
Select to display all on-screen settings in your language of choice: "English",
"Español", "Français", "Italiano", "Deutsch" or "
You can adjust time, display the built-in clock, or make the power go off
automatically.
"Clock Set": Sets the day of the week and the hour of the day.
"Clock Display": Displays the currently set time on the screen when set to "On".
"Sleep Timer": Set the time in minutes (15 minutes, 30 minutes, 45 minutes, 60
minutes, 90 minutes, or 120 minutes) that you want the display to remain on before
shutting off automatically.
Note
If the built-in clock tends to lose time, the internal battery may be exhausted. Please contact
your authorized Sony dealer to have the battery replaced.
"Off": Select to view picture without the benefit of power saving.
"Low"/"High": Select to change brightness and reduce power consumption.
"Picture Off": Select to turn off the picture. Audio stays on with your selected
volume setting.
"On": The display automatically enters the standby mode when a signal is not input
to the video input connectors for more than about 5 minutes. The display
automatically enters the power saving mode when a signal is not input to the other
input connectors for more than about 30 seconds.
"Off": The display is not turned off automatically even when no signal is input to any
connector.
Tip
While in the standby mode, press the 1 (POWER) button on the display or the POWER button
on the remote control to turn the display on. In the power saving mode, the display is turned on
automatically when a signal is input.
"Color System": Select the "Color System" of video signals from "NTSC", "PAL",
"SECAM", "NTSC4.43", "PAL-M", "PAL-N", "PAL60", or select "Auto" to set the
"Color System" automatically.
"Status Display": "On" makes input signal and "Wide Mode" information appear on
the screen for about 20 seconds when the display is turned on, and for about 5
seconds when the input signal is switched, while "Off" disables display of status
information.
Tip
You can display the input signal and "Wide Mode" information by using DISPLAY on the
remote control regardless of the "Status Display" setting.
To highlight an option and to change settings, press
V v B b
/ / / .
Press to confirm the selection.
The "Setup" settings include the following options:
".