Battery Care - Fluke Performance Series User Manual

Battery Care

To prevent personal injury and for safe operation of the Product:
•
•
•
•
•
•
To prevent damage:
•
•
•
•
Do not incinerate the Product and/or battery. Go to Fluke's
website for recycling information.
Shop for Fluke products online at:
Do not put battery cells and battery packs near heat or fire.
Do not put in sunlight.
Do not disassemble or crush battery cells and battery packs.
Remove batteries to prevent battery leakage and damage to
the Product if it is not used for an extended period.
Connect the battery charger to the mains power outlet before
the charger.
Use only Fluke approved power adapters to charge the
battery.
Keep cells and battery packs clean and dry. Clean dirty
connectors with a dry, clean cloth.
Do not expose Product to heat sources or high-temperature
environments such as an unattended vehicle in the sun.
Do not store the Imager on the charger for more than 24
hours as reduced battery life may result.
Charge the Imager for a two-hour minimum at six-month
intervals for maximum battery life. Without use, the battery
will self-discharge in approximately six months. Batteries
stored for long periods will need two to ten charging cycles
for full capacity.
Always operate in the specified temperature range.
MyFlukeStore
www.
Performance Series Thermal Imagers
 Warning
 Caution
  Caution
Maintenance
1.888.610.7664
.com
57