Route Preferences Settings; Route Planning Method Types - ZENEC Prime Z-EMAP66 Series User Manual

Hide thumbs Also See for Prime Z-EMAP66 Series:

Table of Contents

Modify the basic software parameters set during the initial set-up process. See

page 5.

4.3.1 Route preferences settings

The following settings determine how routes are calculated:

Button

You can select from the following route planning method types:

Button

Set the type of vehicle you want to use to navigate the route. Based on

this setting, some of the road types can be excluded from the route, or

some of the restrictions may not be taken into account in route

calculation.

Optimise the route calculation for different situations and vehicle types

by changing the planning method. See page 68.

Select on-road or off-road navigation. See page 58.

Select your preferred road types for the route. See page 69.

Gives a quick route if you can travel at or near the speed limit on all

roads. Usually, the best selection for fast and normal cars.

Results in a route with fewer turns and no difficult manoeuvres. With

this option, you can make ZENEC take, for example, the motorway

instead of a series of smaller roads or streets.

Gives a short route to minimise the travel distance. It can be optimal

for slow vehicles. Searching for a short route regardless of the speed,

this route type is rarely optimal for normal vehicles.

Gives a quick but fuel-efficient route based on the fuel consumption

data. Travel cost and CO

They cannot take elevations, curves and traffic conditions into

consideration.

Function

Description

emission calculations are estimations only.

Table of Contents