Table of Contents
Advertisement
Installation
Precautions
The following steps of installation and connection work
should be done by qualified service personnel or sys-
tem installers and should conform to all local codes.
Before you install and connect the camera, check and
prepare the required peripheral devices and cables.
Before you connect the camera, turn off all devices to
be connected, such as this camera and DVR.
Note:
Do not touch the dome cover's window.
Camera Installation Location
Discuss the installation location for the camera with
your retailer, and select a place that is strong enough
for the installation.
•
Install the camera on a ceiling (concrete, etc.) at a
location that is sufficiently strong to support it.
•
Install the camera body on the foundation section
of the building or sections having sufficient bearing
strength.
Never install or use the camera in the follow-
ing locations
•
Do not install it in areas exposed to direct sunlight
or rain.
•
Do not install the camera near the air outlet of an
air conditioner.
•
Near a swimming pool or other areas where chem-
icals are used.
•
Food preparation areas and other locations where
there are large amounts of steam vapor and oil,
in flammable atmospheres, other special environ-
ments.
•
Areas where radiation, X-rays, strong electric
waves, or magnetism is generated.
•
At sea, in coastal areas, or in areas where corro-
sive gas is being generated.
•
Areas outside of the allowable ambient operating
temperature range.
8
About Static Electricity Removal
Before installing the camera, touch a metal case or
other metallic parts with your hand to remove static
electricity from your body.
Do not install in areas subjected to high amounts of
humidity or dust.
Doing so may cause internal components to damage
more easily or malfunction.
Do not wire cables near power lines.
Tightening the Screws
Screws should be tightened sufficiently in accordance
with the materials and structure of the installation
location. After tightening the screws, visually inspect
them to make sure there is no unevenness and that
each screw is tight.
Removing the Protection Tape
Before using the camera, remove the protection tape.
Caution: Remove the protection tape carefully.
1. Loosen the screws using the wrench and remove
the dome cover as shown below.
2. Remove the protection tape and attach the dome
cover.
Advertisement
Table of Contents
