COLOR TEMP: Use [Near] or [Far] button
-
to select a function.
INDOOR: The color temperature range
>
for the proper white balance is approxi-
mately 3,200°K.
OUTDOOR: The color temperature
>
range for the proper white balance is
approximately 5,100°K.
RED: Set the desired red value. (-100~100)
-
BLUE: Set the desired blue value. (-
-
100~100)
Day/Night setting
1. Select [DAY/NIGHT] option on the [CAMERA SET]
menu.
2. Use [Near] or [Far] button to select mode for day/
night function.
AUTO: You will be able to change the Day/
•
Night mode automatically.
D/N LEVEL: Use [Near] or [Far] button to
-
select a level.
(LOW
MIDDLE
y
DWELL TIME: Use [Near] or [Far] button
-
to select a dwell time. (5, 10, 15, 30 or 60
sec.)
Note:
If you set the AGC to [OFF] or the SHUTTER
HIGH)
y
is set to one of the SHUTTER options except
AUTO on the [EXPOSURE] menu, the AUTO
mode of the DAY/NIGHT function is not avail-
able and [---] mark is displayed.
DAY: Color mode enabled.
•
NIGHT: Black-and-white mode enabled.
•
Motion Detection setting
The motion detection detects the moving objects in
the scene by monitoring changes in brightness level.
You can select the level of sensitivity for motion detec-
tion to 4 zone.
1. Select [MOTION DET] option on the [CAMERA
SET] menu.
2. Use [Near] or [Far] button to select a [ON]
and press [Open] or [Close]. The MOTION
DETECTION menu appears.
3. Use [Near] or [Far] button to select a zone num-
ber (ZONE1 ~ ZONE4) on the [ZONE NUMBER]
option.
4. Use [Near] or [Far] button to set up the ON or
OFF on the [ZONE STATE] option. If you set to
ON, the zone frame appears on the center of the
monitor.
5. Use [In] or [Out] to select an option then use
[Near] or [Far] button to adjust the option
WIDTH: Enlarge or decrease the horizontal
•
size of the zone frame.
HEIGHT: Enlarge or decrease the vertical size
•
of the zone frame.
MOVE X: Moves horizontal position of the zone
•
frame.
MOVE Y: Moves vertical position of the zone
•
frame.
6. Use [SENSITIVITY] option to obtain the optimum
detection level.
7