Carriage Handwheel (X-Axis); Cross Slide Handwheel (Y-Axis) - Grizzly G0768Z Manual

Table Travel
The cross slide table travels in two directions, as
illustrated in Figure 107:
• X-axis (longitudinal)
• Y-axis (cross)
X-Axis or Longitudinal Travel (Left & Right)
Figure 107. Possible directions of cross slide
travel.
These movements are controlled by the carriage
handwheel and cross slide handwheel, (see
Figure 108).
Carriage
Handwheel
(X-Axis)
Figure 108. Table travel controls.
Model G0768/G0769 (Mfd. Since 8/15)
Y-Axis or
Cross Travel
(In & Out)
Cross Slide
Table
Cross Slide
Handwheel
(Y-Axis)

Carriage Handwheel (X-Axis)

Graduated Dial
Increments ................................... 0.01" (0.25mm)
One Full Revolution .......................... 1" (25.4mm)
Use the carriage handwheel to move the carriage
left or right along the bed. Adjust the position of
the graduated scale by holding the handwheel
with one hand and turning the dial with the other.

Cross Slide Handwheel (Y-Axis)

Graduated Dial
Increments .................................0.002" (0.05mm)
One Full Revolution .....................0.08" (2.03mm)
Use this handwheel to move the cross slide table
toward or away from the tooling. The cross slide
handwheel has a direct-read graduated dial,
which will read twice the actual table cross feed
travel.
-63-