13
Select a wireless LAN access point to connect, and then press [Select].
If only [Manual Setup] is displayed, or the SSID of the wireless LAN access point you want to use is not included
in the list, set by following the procedure in
The encryption key entry screen that is suitable for the encryption method of the selected wireless LAN access
point is displayed.
14
Enter the encryption key that you checked in step 1, and then press [OK].
The encryption key varies depending on the wireless LAN access point or security.
If the [WPA Pre-shared Key] is displayed
•
Item
Security
Encryption key
If [WEP Key] is displayed
•
Item
Security
Encryption key
If neither of the above two cases is applied
•
"Setting from the Operator Panel Manually to
Connect".
Description
WPA/WPA2-PSK
Enter the Pre-shared Key.
Description
WEP
Enter the WEP key.
Item
Security
Encryption key
15
If the displayed SSID is the same as the SSID that you checked in step 1,
press [Yes].
When "Connection successful." is displayed, press [Close].
If "Connection failed." is displayed, repeat the procedure from step 5.
- 52 -
2. Setting Up
Description
Disable
No entry is required.