Table of Contents
Advertisement
General Information
• All openings in the wall behind the appliance
or in the fl oor under the appliance should be
sealed.
• Keep appliance area clear and free from
combustible materials, gasoline and other
fl ammable vapors.
• Disconnect the electrical supply prior to
servicing.
• When removing the appliance for service,
disconnect AC power supply and carefully
remove the appliance by pulling forward.
• CAUTION: The oven is heavy – use care when
handling!
• Electrical requirements are listed in the product
specifi cations under the electrical requirements
section.
Recommendations for Unpacking
• Products are shipped on pallets with foam
footings and corrugated inner-packing
• Products are anchored to the pallet using metal
straps that are screwed to the bottom of the
product and the pallet.
• DO NOT remove protective packaging until
you are ready to perform the installation.
• Remove the corrugated cover by lifting it off
the product and remove the innerpacking.
• Detach the product from the metal anchor strip
by removing the attachment screw.
• DO NOT remove the protective wrapping from
the product control panel until the product is
installed.
CAUTION
Avoid any damage to oven vents. The vents
need to be unobstructed and open to provide
proper airfl ow for optimal oven performance.
Recommendations for
Moving
• The appliance is heavy – use extreme care
when handling!
• WARNING: DO NOT use the handle or
oven door to lift the oven. Remove lower
door before installation to ensure that it is
not used to lift the unit. DO NOT remove
the upper door. Make sure latches are
properly locked before removing door to
prevent personal injury to hands and/or
fi ngers. DO NOT lift or carry the door by
the handle.
• Only proper equipment should be used to
move products.
• ALWAYS take steps to protect fl ooring
at the installation location when moving
products. Exposed fl oor surfaces should
be protected by applying laminate or
plywood sheets. Failure to do so may
result in scarring and damaging the
homeowner's fl oor
Site Preparation
Note: It is recommended that a thorough
site inspection be conducted PRIOR to
unpacking and moving this appliance.
• Confi rm available access to adequate
power – see electrical requirements.
– Double oven units require a 50 amp
circuit.
• It is recommended that 3/4" or larger
material be utilized to create a support
platform for this appliance.
• A minimum of 2" (5.1 cm) spacing above
and below the oven trim and 2" (5.1 cm)
spacing from side trims to any adjacent
items or walls is required for ventilation
purposes.
9
Advertisement
Table of Contents
