General Information - TurboChef VDOT730 Installation Manual

General Information

• All openings in the wall behind the appliance
or in the fl oor under the appliance should be
sealed.
• Keep appliance area clear and free from
combustible materials, gasoline and other
fl ammable vapors.
• Disconnect the electrical supply prior to
servicing.
• When removing the appliance for service,
disconnect AC power supply and carefully
remove the appliance by pulling forward.
• CAUTION: The oven is heavy – use care when
handling!
• Electrical requirements are listed in the product
specifi cations under the electrical requirements
section.
Recommendations for
Unpacking
• Products are shipped on pallets with foam
footings and corrugated inner-packing and
exterior hoods.
• Products are anchored to the pallet using metal
straps that are screwed to the bottom of the
product and the pallet.
• DO NOT remove protective packaging until
you are ready to perform the installation.
• To remove the packaging, fi rst remove the
staples located at the bottom perimeter of the
corrugated cover.
• Remove the corrugated cover by lifting it off
the product and remove the innerpacking.
• Detach the product from the metal anchor strip
by removing the attachment screw.
• DO NOT remove the protective wrapping from
the product control panel until the product is
installed.
Recommendations for
Moving
• The appliance is heavy – use extreme care
when handling!
• WARNING: DO NOT use the handle or
oven door to lift the oven. Remove door
before installation to ensure that it is not
used to lift the unit. Do not lift or carry the
door by the handle.
• Only proper equipment should be used to
move products.
• ALWAYS take steps to protect fl ooring
at the installation location when moving
products. Exposed fl oor surfaces should
be protected by applying laminate or
plywood sheets. Failure to do so may
result in scarring and damaging the
homeowner's fl oor
CAUTION
Avoid any damage to oven vents. The vents
need to be unobstructed and open to provide
proper airfl ow for optimal oven performance.
CAUTION
The cooling fan should be operating when the
unit is in operation. If you notice the cooling
fan is not operating or you observe unusual or
excessive noise coming from the cooling fan,
contact an Authorized Service Center before
continuing operation. Failure to do
so can result in damage to the oven or
surrounding cabinets.
9