Table of Contents
Advertisement
Performance Checklist – Lower Oven
Headline
Loading the Software
This fi rst time you turn on the oven after installation, the oven will load the software. This process
should take no longer than 10 minutes. DO NOT attempt to operate the oven while the software
is loading.
Note: If necessary to relaunch the software, hold down the left (upper) power off button for 5
seconds.
Note: To fully relaunch software and the memory and program code (the "fi rmware"), the oven
must be powered off at the circuit breaker.
Control Panel
LED Light
Ring
A qualifi ed installer should carry out the
following checks:
1. Check oven bake function–bake element
on full power, center and outside broil
elements at partial power. Convection
bake function– bake and broil elements
the same with the convection fan on.
2. Check high broil function–both broil
elements at full power. Convection broil
function is the same with convection fan
on.
3. Check low broil function–inner broil
element only.
Power Off
Digital
Speedcook Oven
Display
Speedcook Oven
Favorites
Food item
Cook mode
Cookbooks
Search
02:55
Speedcook
Speedcook
Clock
Oven Light
Oven Lock
4. Check self-clean function–Door will lock in
CAUTION: Do not run self-clean cycle check
for more than 10 minutes with the oven racks
and rack supports inside oven to avoid
discoloration due to the high temperature.
Any adjustments necessary that are a result
of the installer not following instructions will
be the responsibility of the installer, dealer or
the end user of the product.
14
Power Off
Lower Oven
Lower Oven
®
Control
Lower
Lower
Panel
Oven Lock
Oven Light
approximately 30 seconds, the center and
outside broil elements will turn on and the
bake element will turn on at partial power.
Check broil elements through window
to make sure they are on, then abort
self-clean cycle to unlock door.
USB Port
(Top of Control Panel)
Advertisement
Table of Contents
