Table of Contents
Advertisement
Audio 2.1, 4.1, 5.1, or 7.1-channel configuration
Port
Light Blue (Rear
panel)
Lime (Rear panel)
Pink (Rear panel)
Lime (Front panel)
To configure a 7.1-channel audio output:
8.
USB 3.0 ports. These 9‑pin Universal Serial Bus (USB) ports are for USB 3.0/2.0
devices.
•
•
9.
DisplayPort. This port is for DisplayPort‑compatiable devices.
10.
HDMI port. This port is for a High‑Definition Multimedia Interface (HDMI) connector,
and is HDCP compliant allowing playback of HD DVD, Blu‑Ray, and other protected
content.
11. DVI-D port. This port is for any DVI‑D compatible device.
DVI‑D can not be converted to output from RGB Signal to CRT and is not compatible with
DVI‑I.
12.
USB 2.0 ports. These 4‑pin Universal Serial Bus (USB) ports are for USB 2.0/1.1
devices.
1-6
Headset
2.1-channel
Line In
Line Out
Mic In
-
Use a chassis with HD audio module in the front panel to support a 7.1‑channel audio
output.
We strongly recommend that you connect USB 3.0 devices to USB 3.0 ports for faster
and better performance from your USB 3.0 devices.
Due to the design of the Intel
USB 2.0 and USB 3.0 ports are controlled by the xHCI controller. Some legacy USB
devices must update their firmware for better compatibility.
4.1-channel
Rear Speaker Out
Rear Speaker Out
Front Speaker Out
Front Speaker Out
Mic In
-
100 series chipset, all USB devices connected to the
®
5.1-channel
7.1-channel
Rear Speaker Out
Front Speaker Out
Bass/Center
Bass/Center
-
Side Speaker Out
Chapter 1: Product introduction
Advertisement
Table of Contents
