Installing The Intenza+ Water Filter - Philips HD8652/59 Manual

English
10

Installing the Intenza+ water filter

3 When the warning light flashes quickly, turn the control dial to the hot
water icon and wait a few seconds.
-
The warning light goes out and some water comes out of the hot
water/steam wand or automatic milk frother.
4 After a few seconds, when hot water stops coming out of the hot
water/steam wand and the warning light flashes slowly, turn the control
dial back to the single bean icon.
-
The machine is heating up and the on/off button flashes slowly.
-
When the machine has heated up, it performs an automatic rinsing
cycle to clean the internal circuit with fresh water. Water flows from
the coffee spout.
-
When the on/off button lights up continuously, the machine is ready
for the manual rinsing cycle.
Note:You can stop the automatic rinsing cycle by pressing the espresso
or the cappuccino button.
Note:The automatic rinsing cycle also takes place 60 minutes after the
appliance switches to standby mode or switches off.
We advise you to install the Intenza+ water filter as this prevents scale
build-up in your machine. You can buy the Intenza+ water filter separately.
For more details, see chapter 'Guarantee and support', section 'Ordering
maintenance products'.
1 Remove the small white filter from the water tank and store it in a dry
place.
Note: Please keep the small white filter for future use. You will need it for
the descaling process.
2 Remove the filter from its packaging and immerse it in cold water with
the opening pointing upwards. Press the sides of the filter gently to let
out the air bubbles.