Installing The Intenza+ Water Filter - Philips HD8823 Manual

Memo Memo Memo
Aroma plus
Espresso Espresso lungo Co ee
1 Hot water
X
X 2 Steam
Calc
clean
Memo
Co ee
1
X
X 2
Memo Memo Memo
Aroma plus
Espresso Espresso lungo Co ee
Hot water
1
X
X 2 Steam
Calc
clean

Installing the Intenza+ water filter

1 Place a container under the coffee dispensing spout.
2 Make sure the ESPRESSO, ESPRESSO LUNGO, COFFEE and HOT
WATER/STEAM buttons light up continuously.
3 Press the COFFEE button.
-
The machine starts to brew a cup of coffee to prepare the inner circuit
for use.This coffee is not drinkable.
4 Empty the container after the brewing cycle is finished.
5 Place the container back under the classic milk frother.
6 Press the HOT WATER/STEAM button once. The machine starts
dispensing water.
-
The HOT WATER/STEAM button flashes slowly.
7 Let the machine brew hot water until the no water light lights up
continuously.
Note: If you want to stop the manual rinsing cycle, press the HOT
WATER/STEAM button, to restart the cycle press the HOT
WATER/STEAM button again.
8 Fill the water tank with fresh water up to the MAX level.
Note: The automatic rinsing cycle starts when the machine has been in
stand-by mode, or switched off for more than 30 minutes. When you have
not used the machine for 2 or more weeks, you will need to perform a
manual rinse cycle.
The machine is ready for use.
We advise you to install the Intenza+ water filter as this prevents scale
build-up in your machine. You can buy the Intenza+ water filter separately.
For more details, see chapter 'Guarantee and support', section 'Ordering
maintenance products'.
English
13