Frothing Milk; Hot Water - Philips HD8652/59 Manual

Hot water

9 Place a cup under the automatic milk frother. Perform a quick clean
dispensing hot water for 3-5 seconds after brewing a cappuccino, see
chapter 'Cleaning and maintenance', section 'Quick Clean of the milk
system'.
10 Remove the milk tube connector from the automatic milk frother.
11 Plug the milk connector to the pin on the milk container lid and put the
milk container in the fridge.
Note: After dispensing a milk based beverage perform a quick clean of
the milk system by dispensing hot water for 5 seconds.

Frothing milk

Warning: Danger of burning! Dispensing may be preceded by small
jets of hot water. When steam is used, the hot water/steam wand
and automatic milk frother could be hot. Only grab the steam
wand by its protective handle.
1 Follow steps 1 to 5 from 'Brewing cappuccino' and turn the dial to the
steam/milk clean icon to froth milk.
2 Turn the control dial to one or two coffee beans icon to stop frothing
milk.
Warning: Danger of scalding! Dispensing may be preceded by
small jets of hot water. Use the appropriate protective handle
only.
1 Make sure the on/off button lights up continuously. If the on/off button
flashes slowly, the machine is heating up.
2 Remove the automatic milk frother. Keep the protective handle on the
hot water/steam wand.
3 Place a cup under the hot water/steam wand.
4 Turn the control dial to the hot water icon.
-
Water comes out of the hot water/steam wand.
English
13