Uplink Module Leds; Fan Module Leds - Cisco Nexus 9396TX Hardware Installation Manual

Uplink Module LEDs

Uplink Module LEDs
The Status (STS) LED is located on the left side of the uplink module. There is an ACT LED located below
each two uplink ports. Next to each ACT LED are two triangular port LEDs that point to the top or bottom
to identify their port as being the top or bottom port.
LED
STS
ACT
(port)

Fan Module LEDs

The fan module LED is located below the air holes on the front of the module.
LED
STS
Cisco Nexus 9396TX NX-OS Mode Switch Hardware Installation Guide
56
LED
(port) Green
Amber
Off
Color
Green
Red
Off
On (white)
Off
Green
Off
Color Status
Green The fan module is operational.
Red The fan module is not operational (fan is probably not functional).
Off Fan module is not receiving power.
Color
Status
This module is operational.
Temperature is not operational.
The module is not receiving power.
The two ports above this LED are enabled.
The two ports above this LED are not enabled.
The port is connected with a transceiver or other connector.
The port is not connected.
Status
Port admin state is 'Enabled', SFP
is present and the interface is
connected (that is, cabled, and the
link is up).
Port admin state is 'Disabled, or the
SFP is absent, or both.
Port admin state is 'Enabled' and
SFP is present, but interface is not
connected.
LEDs