Table of Contents
Advertisement
Overview
4
Out-of-band management port (RJ-45 port)
5
48 10GBASE-T copper ports (supporting
100-Megabit, 1-Gigabit, and 10-Gigabit speeds)
for connections to other devices
You can use the 10GBASE-T ports to connect this switch to up to 48 devices using speeds of 100 Megabits,
1 Gigabit, or 10 Gigabits.
To determine which transceivers, adapters, and cables are supported by this switch, see the
Modules Compatibility Information
The following figure shows the hardware features seen from the fan side of the chassis.
1
2
3
9
10
document.
Screw holes (2) for
5
attaching the grounding
lug.
Notch in both sides of the
6
chassis for locking the fan
end of the chassis to the
bottom-support rails.
Two power supply
7
modules (AC power
supply shown)
Power supply slots are
numbered 1 on the left
and 2 on the right (as seen
when looking at the power
supplies).
Cisco Nexus 9396TX NX-OS Mode Switch Hardware Installation Guide
Screw holes (4) for attaching a center-mount rack
bracket for two-post racks (one bracket for each
of two sides)
Screw holes (2) for attaching a front-mount
bracket for four-post racks (one bracket on each
of two sides)
Chassis LEDs are as
follows:
• Beacon (BCN)
• Status (STS)
Screw holes (4) for
attaching a center-mount
rack bracket for two-post
racks (one bracket for
each of two sides).
Screw holes (2) for
attaching a front-mount
bracket for 4-post racks (1
bracket on each of 2
sides).
Overview
Cisco Transceiver
3
Advertisement
Table of Contents
