Uplink Module Leds; Fan Module Leds; Power Supply Leds - Cisco Nexus 9396PX Hardware Installation Manual

Uplink Module LEDs

Uplink Module LEDs
The Status (STS) LED is located on the left side of the uplink module. There is an ACT LED located below
each two uplink ports. Next to each ACT LED are two triangular port LEDs that point to the top or bottom
to identify their port as being the top or bottom port.
LED
STS
ACT
(port)

Fan Module LEDs

The fan module LED is located below the air holes on the front of the module.
LED
STS

Power Supply LEDs

The power supply LEDs are located on the left front portion of the power supply. Combinations of states
indicated by the Okay (
table.
Cisco Nexus 9396PX NX-OS Mode Switch Hardware Installation Guide
58
Color
Green
Red
Off
On (white)
Off
Green
Off
Color Status
Green The fan module is operational.
Red The fan module is not operational (fan is probably not functional).
Off Fan module is not receiving power.
) and Fault (
Status
This module is operational.
Temperature is not operational.
The module is not receiving power.
The two ports above this LED are enabled.
The two ports above this LED are not enabled.
The port is connected with a transceiver or other connector.
The port is not connected.
) LEDs indicate the status for the module as shown in the following
LEDs