Table of Contents
Advertisement
For optimal battery performance, do not charge the appliance after
every use. Only charge the appliance when the battery pack is low (i.e.
when the roller brush does not turn as fast as usual).
1
Switch off the appliance before you charge it.
Place the stick in upright position (Fig. 7).
Insert the small plug into the socket on the sweeper base (Fig. 8).
Insert the adapter into a wall socket.
-
The charging light is on continuously during charging and after the
battery pack is fully charged. The charging light goes out when you
disconnect the appliance from the mains
Note: The charging light does not give any information about the charge level
of the battery pack.
using the appliance
1
To unlock the stick from its upright position, put your foot on top
of the sweeper base to prevent it from tilting. Then pull the handle
towards you. (Fig. 9)
Do not put your foot on the on/off button or the dirt tray release
button.
Press the on/off button to switch on the appliance (Fig. 10).
To switch off the appliance, press the on/off button again.
Use the side brushes to clean the floor along the walls (Fig. 11).
To bend the stick, press the stick bending button (Fig. 4).
-
With a bent stick, you can clean areas under furniture without
bending your back (Fig. 5).
5
To use the sweeper as a handheld appliance, remove the stick and
hold the sweeper by the lower handle (Fig. 12).
For better grip, push the handle towards the front of the appliance until it
is at a 45-degree angle to the base.
English
9
Advertisement
Table of Contents
