Table of Contents
Advertisement
Erasing Settings
Erase SEL
Select "Yes, On next reset" to erase all system event logs upon next system boot. Select
"Yes, On every reset" to erase all system event logs upon each system reboot. Select "No"
to keep all system event logs after each system reboot. The options are "No", "Yes, On next
reset", and "Yes, On every reset".
When SEL is Full
This feature allows the user to determine what the BIOS should do when the system event
log is full. Select Erase Immediately to erase all events in the log when the system event log
is full. The options are Do Nothing and Erase Immediately.
Note: After you've made a change on a setting below, please be sure to reboot the
system for the change to take effect.
BMC Network Configuration
The following items will be displayed:
•
IPMI LAN Selection: This feature displays the IPMI LAN setting. The default setting is
Failover.
•
IPMI Network Link Status: This feature displays the IPMI Network Link status. The default
setting is Dedicated LAN.
•
Station MAC Address: This feature displays the Station MAC address for this computer.
Mac addresses are 6 two-digit hexadecimal numbers.
•
VLAN: This feature displays the status of VLAN support. The default setting is Disabled.
•
IPv4 Address Source: This feature displays the source of IPv4 addresses. The default
setting is Static.
•
Station IP Address: This feature displays the Station IP address for this computer. This
should be in decimal and in dotted quad form (i.e., 192.168.10.253).
•
Subnet Mask: This feature displays the sub-network that this computer belongs to. The
value of each three-digit number separated by dots should not exceed 255.
•
Gateway IP Address: This feature displays the Gateway IP address for this computer. This
should be in decimal and in dotted quad form (i.e., 192.168.10.253).
•
IPv6 Address Status: This feature displays the IPv6 address status. The default setting is
Disabled.
131
Chapter 4: UEFI BIOS
Advertisement
Table of Contents
