Supermicro SuperServer 1029U-TN10RT User Manual page 44

SuperServer 1029U-TN10RT User's Manual
Installing a Drive
1. Remove the dummy drive, which comes pre-installed in the drive carrier, by removing
the screws securing the dummy drive to the carrier. These screws are not used to
mount the actual hard drive.
Figure 3-7. Removing the Dummy Drive from a Carrier
2. Insert a drive into the carrier with the PCB side facing down and the connector end
toward the rear of the carrier. Align the drive in the carrier so that the screw holes line
up. Note that there are holes in the carrier marked "SATA" to aid in correct installation.
3. Secure the drive to the carrier with four M3 screws as illustrated below. These screws
are included in the chassis accessory box.
4. Insert the drive carrier with the disk drive into its bay, keeping the carrier oriented so
that the hard drive is on the top of the carrier and the release button is on the right side.
When the carrier reaches the rear of the bay, the release handle will retract.
5. Push the handle in until it clicks into its locked position
44