Icom IC-M423G Instruction Manual page 69

D Receiving a Position Request Call
When a Position Request Call is received:
➥ The alarm sounds for 2 minutes.
➥➥ "RCVD POS REQUEST" is displayed. The backlight blinks
for 2 minutes.
q Push [ALARM OFF] to stop the alarm and the blinking
backlight.
• Even if you do not push [ALARM OFF], the alarm stops after 2
minutes, and then the screen in step w is displayed.
w Push a softkey to select your desired action.
[IGN]
➥➥➥ P ush to ignore the Call and return to the normal operating
[INFO]
➥➥➥ P ush to display the Received call information. (p. 63)
[UNABLE] (For only USA version transceivers)
➥➥➥ P ush to transmit the "Unable to Comply" acknowledgement.
[ABLE] (For only USA version transceivers)
➥➥➥ P ush to transmit the "Able to Comply" acknowledgement.
[ACK]
➥➥ Push to display the "POSITION REPLY" screen and send
USA version
mode.
• The transceiver exits the DSC mode.
• " " continues to blink and the Call is stored in the Received
Call Log.
• The call is saved in the DSC Log.
• The call is saved in the DSC Log.
a reply to the Call. (p. 49)
When "POSITION ACK" is set to "Auto TX," the transceiver
automatically replies to the Call. In that case, both the TX
and RX calls are stored in the Transmitted and Received
Call Logs.
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
59