Before Using Your Appliance; Use - Pelgrim Novecento NF940 Manual

Before using your appliance

Gashob
Burning in of the enamel
The burners cause the saucepan supports
I
to get extremely hot. In time the enamel on
the support points can burn in. This cannot
be prevented and is not covered by the
guarantee.
Burner caps
Check regularly whether the caps of the
I
burners are properly in position on the
burner depressions. Improper positioning
can make it difficult to light the burners,
give rise to an irregular gas flame, or
damage the burner caps.
Oven
Prepare for use
I Remove the blue protective foil from the
stainless steel doors.
Remove all accessories from the oven and
I
clean them thoroughly using a dish-
washing detergent. Switch on the closed,
empty oven at the maximum temperature
for about thirty minutes, after which the
grilling element should be switched on for
a period of fifteen minutes. Let the oven
cool off and clean it with warm water.
Please note:
When the oven is heated to a high
temperature for the first time, you will smell a
"new appliance" odour. This is to be
expected.
Clock
If you have not set a time, 0.00 and the word
"AUTO" will blink.
Setting the time
I There is a normal clock on the display that
shows the time. Press the
buttons at the same time.
I Press the –/+ buttons until the correct time
is reached.
After a few seconds the time has been set
I
and the appliance is set to manual control.
Setting the signal
Press the – buttons for adjusting the signal.
I
Three different signals can be set.
fig. 1
and