Directions For Storage And Handling The Equipment; Storage Of The Equipment; Uncrating; Moving The Equipment - Ojeda NBH Series Installation And Operation Manual

If the equipment will be kept in storage, it is suggested to keep it in its original packing. In case you
need your equipment to be inactive for a long period of time after being used, verify that it has been
unplugged. After cleaning it thoroughly with a damp cloth, lukewarm water and neutral soap and
carefully drying it, cover it with a polyethylene film or similar waterproof material.
The following procedure is recommended for uncrating the unit:
Remove the outer package by carefully cutting the shrink wrap and removing the 4 corner posts
and top lid. Inspect for concealed damage. Immediately file a claim with the freight carrier if there is
damage. Move your unit as close to the final location as possible before removing the wooden skid.
The unit is shipped with casters to facilitate moving the unit into position.
Disconnect the power cord plug from the wall outlet. Remove product, then defrost, and clean the
freezer. Secure all loose items such as baskets and fix the lids by taping them securely in place to
prevent damage. In the moving vehicle, secure the freezer in an upright position and cover it to protect
the outside of the cabinet.
THIS UNIT CANNOT BE INSTALLED IN ENVIRONMENTS WITH EXPLOSIVE GASES. THE
EQUIPMENT IS DESIGNED ONLY FOR INDOOR OPERATION.
The unit must be located in an indoor environment.
For the correct performance of the refrigerating system, it is very important to leave at least 10 cm
(4") of free space both at the sides and back to allow proper air circulation. Do not block the grills on
the side or back of the cabinet.

STORAGE OF THE EQUIPMENT

PLACING AND INSTALLING EQUIPMENT
ENVIRONMENTAL CONDITIONS

MOVING THE EQUIPMENT

UNCRATING

www.ojedausa.com | 4