Table of Contents
Advertisement
-
Do not keep the unit running unloaded. UNPLUG IT when you are not planning to use it.
Using any electrical or electronic equipment entails the compliance with some fundamental rules.
-
Do not touch the unit with wet hands or feet.
-
Do not install the equipment outdoors.
-
Do not remove or ignore safety devices.
-
Do not leave objects on top of the unit.
-
Do not climb on top of the unit.
-
Never use direct or indirect water jets on the unit.
-
Do not allow the electronic control to be adjusted by customers or unqualified personnel.
-
Under no circumstance should you block the side or back grille of the unit.
THE MANUFACTURER DOES NOT ASSUME ANY RESPONSIBILITY ARISING FROM DAMAGES
CAUSED BY IMPROPER, INCORRECT OR ERRONEOUS USE.
It is important to instruct the user on the operation of the equipment according to this instruction
manual, and to make sure that said manual is within reach of any operator that might use the unit.
Regularly and carefully cleaning and defrosting the equipment prevents deterioration and product
alteration.
It is recommended to remove the frost accumulated before reloading the freezer or anytime when
one quarter inch of frost has accumulated.
The unit will have to be manually defrosted. The manual defrost frequency will depend on the units
usage, environment, and the amount of frost accumulated.
1.
Make sure the drain plug is removed and the unit is moved close to a floor drain.
2.
Unplug the unit until all the frost is gone.
3.
When the ice has melted wipe up any water left on the freezer floor.
4.
Be sure to replace the drain plug before moving the freezer back into position.
5.
Allow the freezer to refrigerate and cycle before placing the wire baskets and product back into the freezer
To defrost while keeping the freezer plugged in place a clean dry soft cloth over the product to catch
the frost that will be removed. Remove the frost using a plastic scrapper trying to eliminate as much
frost as possible.
Wash any removable parts, the freezer interior, and exterior with mild detergent and warm water.
Wipe dry. DO NOT USE HARSH CLEANERS ON THESE SURFACES. Do not use razor blades or
other sharp instruments, which can scratch the appliance surface.
MAINTENANCE GUIDELINES
REMOVAL OF FROST
CLEANING THE UNIT
CAUTION
www.ojedausa.com | 8
Advertisement
Table of Contents
