Cleaning The Inside - Ojeda NBH Series Installation And Operation Manual

DAMP OBJECTS STICK TO COLD METAL SURFACES. DO NOT TOUCH THE INTERIOR METAL
After defrosting, wash the inside surfaces of the freezer with a solution of two tablespoons of baking
soda in one quarter of a gallon (1.1 liters) warm water. Rinse and dry. Wring excess water out of the
sponge or cloth when cleaning in the area of the controls, or any electrical parts.
Wash the removable parts and door basket with the baking soda solution, or mild detergent and
warm water. Rinse and dry. Never use metallic scouring pads, brushes, abrasive cleaners, or alkaline
solutions on any surface. Do not wash removable parts in a dishwasher. Do not shower water with a
hose nor use ammonia based cleaners.
THE LOWER SIDE OF THE GLASS LIDS IS PROVIDED WITH A SPECIAL FILM. DO NOT USE
RAZOR BLADES OR OTHER SHARP INSTRUMENTS WHICH CAN SCRATCH THIS SURFACE
Wash the cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean
soft cloth. Do not shower water with a hose nor use ammonia based cleaners.
Clean every week with only a dam p piece of cloth and neutral soap each external and internal
surface, and dry them with a clean soft cloth.
Never use flammable or abrasive products. The unit must never be cleaned with water jets.
IMPORTANT: During maintenance and cleaning operations, make sure that good visibility conditions
exist in the working area, using other light sources in case it is needed. Be very careful when
working with moving and/or high-temperature parts.
If lids must be removed:
1 - Stand in front of the freezer
2 - Assure that the lower lid is totally closed to the left side of the freezer
3 - To remove the top lid, run it open to its maximum, handling it by both sides push it to the back.
This allows the lid to get out from the front rail where it runs, then remove it pulling the lid out from
the rear rail. Handle the lid carefully and place it in a straight safety place.
4 - Repeat step number 3 for removing the lower lid.
5 - To install the lids again, reverse the previous step s starting with the lower lid.
WARNING
SURFACES WITH WET OR DAMP HANDS.
WARNING
AND DAMAGE THE FILM.
CLEANING THE OUTSIDE
LID REMOVAL

CLEANING THE INSIDE

www.ojedausa.com | 9