Vivotek SUPREME use IP FE9582-EHNV User Manual page 344

VIVOTEK
http://<servername>/cgi-bin/camctrl/camctrl.cgi?[<parameter>] [&<parameter>...]
Example:
http://myserver/cgi-bin/camctrl/camctrl.cgi?genpan
Response:
HTTP/1.0 200 OK\r\n
Cache-control: no-cache\r\n
Pragma: no-cache\r\n
\r\n
pan=4117\r\n
PARAMETER VALUE
getversion <string>
getaction idle,
autopan,
tracking,
tour,
patrol,
getpan 0, <positive integer>
getpanangle <integer>
gettilt 0, <positive integer>
gettiltangle <integer>
getzoom 0, <positive integer>
getratio <decimal>
getfocus 0, <positive integer>
getminspeedlv 0, <positive integer>
getmaxptspeedlv 0, <positive integer>
getmaxzspeedlv 0, <positive integer>
getmaxfspeedlv 0, <positive integer>
344 - User's Manual
DESCRIPTION
Get the version of the PTZ control module.
Get the current status of the camera.
* We support this parameter when the version number (getversion) is
equal or greater than 5.0.0.12
Get the current pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
Get the current pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
Get the current tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
Get the current tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
Get the current zoom position.
Get the current zoom ratio.
Get the current focus position.
Get the minimum speed level of the PTZ control. Normally, the speed
level is '0,' which denotes halting a continuous movement.
Get the maximum speed level of pan/tilt moving.
*Only available when "capability_camctrl_c<0~(n-1)>_buildinpt" > 0
Get the maximum speed level of zoom moving.
Get the maximum speed level of focus moving.